Program management
13.14 V24
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
527
13.14 V24
13.14.1 Reading-in and reading-out archives
You have the option of reading-out and reading-in archives in the "Program Manager"
operating area as well as in the "Start-up" operating area via the serial V24 interface.
Availability of the serial V24 interface
● SINUMERIK Operate in the NCU
The softkeys for the V24 interface are available as soon as option module is connected
and the slot is occupied.
● SINUMERIK Operate on PCU 50.3
The softkeys for the V24 interface are always available.
Reading-out archives
The files to be sent (directories or individual files) are zipped in an archive (*.ARC).
If you send an archive (*.arc), this is sent directly without being additionally zipped. If you
have selected an archive (*.arc) together with an additional file (e.g. directory), then these
are zipped into a new archive and are then sent.
Reading-in archives
Only archives can be read-in via the V24 interface. These are transferred and then
subsequently unzipped.
Note
Series commissioning archive
If you read-in a series commissioning archive via the V24 interface, then this is immediately
activated.
Externally processing the punched tape format
If you wish to externally process an archive, then generate this in the punch tape format.
Using the SinuCom commissioning and Servicetool SinuCom ARC, you can process the
archive in the binary format and in the series commissioning archive.
To Next Page
Loading...
Need help?
General
