Program management
13.6 Displaying the program in the Preview.
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
511
13.6 Displaying the program in the Preview.
You can show the content on a program in a preview before you start editing.
Procedure
1. Select the "Program manager" operating area.
2. Select a storage location and place the cursor on the relevant
program.
3. Press the ">>" and "Preview window" softkeys.
The "Preview: ..." window opens.
4. Press the "Preview window" softkey again to close the window.
13.7 Selecting several directories/programs
You can select several files and directories for further processing. When you select a
directory, all directories and files located beneath it are also selected.
Note
If you have selected several directories and one of them closes, then selection of the
directory and all of the files contained therein is canceled.
Procedure
1. Select the "Program manager" operating area.
2. Choose the desired storage location and position the cursor on the file
or directory from which you would like your selection to start.
3. Press the "Select" softkey.
To Next Page
Loading...
Need help?
General
