Program management
13.10 Renaming file and directory properties
Milling
516 Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
- OR -.
Press the "Cancel" softkey to cancel the process.
13.10 Renaming file and directory properties
Information on directories and files can be displayed in the "Properties for ..." window.
Information on the creation date is displayed near the file's path and name.
You can change names.
Changing access rights for NC data
Access rights for execution, writing, listing and reading are displayed in the "Properties"
window.
● Execute: This is used for the selection
● Write: Controls the changing and deletion of a file or a directory
You can set the access rights from keyswitch 0 to the current access level. If an access level
is higher than the current access level, it cannot be changed.
Note
Access rights cannot be defined for files outside the NC memory (e.g. local drive).
Procedure
1. Select the Program manager.
2. Choose the desired storage location and position the cursor on the file
or directory whose properties you want to display or change.
...
3. Press the ">>" and "Properties" softkeys.
The "Properties from ..." window appears.
4. Enter any necessary changes.
5. Press the "OK" softkey to save the changes.
To Next Page
Loading...
Need help?
General
