EasyManuals Logo

Siemens SINUMERIK 840D Operating Manual

Siemens SINUMERIK 840D
610 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #555 background imageLoading...
Page #555 background image
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
555
Service Planner (828D only)
18
18.1 Performing and monitoring maintenance tasks
With the "Service Planner", maintenance tasks have been set up that have to be performed
at certain intervals (e.g. top up oil, change coolant).
A list is displayed of all the maintenance tasks that have been set up together with the time
remaining until the end of the specified maintenance interval.
The current status can be seen in the status display.
Messages and alarms indicate when a task has to be performed.
Acknowledging a maintenance task
Acknowledge the message when a maintenance task has been completed.
Note
Protection level
You require protection level 2 (service) to acknowledge completed maintenance tasks.
Service Planner
Display Meaning
Pos Position of the maintenance task in the PLC interface.
Maintenance task Name of the maintenance task.
Interval [h] Maximum time until next servicing in hours.
Remaining time [h] Time until the interval expires in hours.
Status
Display of the current status of a maintenance task.
The maintenance task has been started.
The maintenance task is completed.
The maintenance task is deactivated.

Table of Contents

Other manuals for Siemens SINUMERIK 840D

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 840D and is the answer not in the manual?

Siemens SINUMERIK 840D Specifications

General IconGeneral
SeriesSINUMERIK 840D
AxesUp to 31
ChannelsUp to 10
Operating SystemWindows-based
Power Supply24 V DC
Control Unit TypeCNC
InterfaceEthernet, PROFIBUS
DisplayTFT color display
InterpolationSpline
PLCIntegrated PLC
Data StorageCompactFlash, USB

Related product manuals