Easy Message (828D only)
16.7 Making settings for Easy Message
Milling
550 Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
16.7 Making settings for Easy Message
You can change the following Messenger configuration in the "Settings" window:
● Name of the controller that is part of an SMS message
● Number of sent messages
– The SMS counter provides information on all sent messages.
– Limit the number of sent messages in order to receive an overview of the costs
through SMS messages, for example.
Setting the SMS counter to zero
When a set limit is reached, no further SMS messages are sent.
Press the "Reset SMS counter" softkey to reset the counter to zero.
Requirement
The connection has been established to the modem.
Procedure
1. Press the "Settings" softkey.
2. Enter an arbitrary name for the controller in the "Machine name" field.
3. If you want to limit the number of sent SMS messages then select the
"Specify limit for SMS counter" entry and enter the desired number.
When the maximum number of messages is reached, you obtain a
corresponding error message.
Note
Check the SMS log to see the exact time when the limit was reached.
- OR -
3. Press the "Default" softkey.
If you have freely selected a machine name, this is replaced by a
default name (e.g. 828D).
To Next Page
Loading...
Need help?
General
