Siemens SINUMERIK 840D

Creating G code program
6.8 Selection of the cycles via softkey
Milling
206 Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
6.8 Selection of the cycles via softkey
Overview of machining steps
The following softkey bars are available to insert machining steps.
All of the cycles/functions available in the control are shown in this display. However, at a
specific system, only the steps possible corresponding to the selected technology can be
selected.
⇒
⇒
⇒
⇒
⇒
⇒