Machining the workpiece
4.8 Intervening in the program sequence
Milling
152 Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
Activating program control
You can control the program sequence however you wish by selecting and clearing the
relevant check boxes.
Display / response of active program controls:
If a program control is activated, the abbreviation of the corresponding function appears in
the status display as response.
Procedure
1. Select the "Machine" operating area.
2.
Press the
<AUTO> or
<MDA>
key.
3. Press the "Prog. ctrl.” softkey.
The "Program control" window appears.
See also
Setting for automatic mode (Page 170)
To Next Page
Loading...
