Programming technological functions (cycles)
8.4 Turning - only for G code programs
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
359
Procedure
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Turning" softkey.
3. Press the "Groove" softkey.
The "Groove" input window opens.
4. Select one of the three groove cycles with the softkey:
Simple groove cycle
The "Groove 1" input window opens.
- OR
Groove cycle with inclines, radii, or chamfers.
The "Groove 2" input window opens.
- OR
Groove cycle on an incline with inclines, radii or chamfers.
The "Groove 3" input window opens.
Parameters, G code program
PL Machining plane
SC Safety clearance mm
F Feedrate mm/min
Parameters Description Unit
Machining
∇ (roughing)
∇∇∇ (finishing)
∇ + ∇∇∇ (roughing and finishing)
Position
Groove position/reference point:
X0 Reference point in X ∅ mm
Z0 Reference point in Z mm
B1 Groove width mm
T1 Groove depth ∅ (abs) or groove depth referred to X0 (inc)
To Next Page
Loading...
Need help?
General
