Siemens SINUMERIK 840D

Programming technological functions (cycles)
8.5 Contour turning - only for G code programs
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
389
Procedure
1. The part program to be executed has been created and you are in the
editor.
2. Press the "Turning" and "Contour turning" softkeys.
3. Press the "Contour" and "Contour call" softkeys.
The "Contour Call" input window opens.
4. Assign parameters to the contour selection.
Parameter Description Unit
Contour selection
 Contour name
 Labels
 Subprogram
 Labels in the subprogram
Contour name CON: Contour name
Labels
 LAB1: Label 1
 LAB2: Label 2
Subprogram PRG: Subprogram
Labels in the
subprogram
 PRG: Subprogram
 LAB1: Label 1
 LAB2: Label 2