Siemens SINUMERIK 840D

Programming technological functions (cycles)
8.5 Contour turning - only for G code programs
Milling
Operating Manual, 03/2010, 6FC5398-7CP20-1BA0
405
Parameters
Description Unit
Set machining area
limits
Set machining area limits
 Yes
– XA: 1. Limit XA ∅
– XB: 2. Limit XB ∅ (abs) or 2nd limit referred to XB (inc)
– ZA: 1. Limit ZA
– ZB: 2. Limit ZB (abs) or 2nd limit referred to ZB
 No
N Number of grooves
DP Distance between grooves (inc) mm