Simrad SU90 - Configuring and Testing the Interface to the Speed Log

Interfacingperipheralequipment
Conguringandtestingtheinterfacetothespeedlog
Observetherelevanttestprocedureforyourspeeddatasource.
Topics
•Speedlog(seriallineinterface)onpage157
•(D)GPSspeeddata(seriallineinterface)onpage157
Speedlog(seriallineinterface)
Purpose
Observethefollowingproceduretosetupandtestthespeedloginput.
Relatedtopics
•Connectingthespeedlogonpage142
Procedure
1OpentheInstallationmenuasdescribedinOpeningtheInstallationmenuon
page156.
2ClickI/OSetup→Sensors→Speed→SpeedLog.
3ObservethattheSensorCongparameterdialogappearsatthebottomofthemenu
eld.
4ChangethesettingsintheSensorCongparameterdialogtosuityourrequirements
fortheserialline.
Remembertosetcorrectbaudrate,andsetTalkertoNone.
5ClickClosetoexittheSensorCongparameterdialog.
6Checkthatthespeedread-outintheStatusparameterdialogcorrespondstothe
readingfromthevessel’sspeedlog.
7Ifyouneedorwishtomonitorthedetaileddatatrafconthecommunicationline,
observethededicatedproceduresinsectionMonitoringthetrafconaserialor
Ethernetlineonpage132.
(D)GPSspeeddata(seriallineinterface)
Purpose
IftheGPSisusedforthespeeddatainput,waitwiththistestuntiltheGPSpositiondata
aretested.Whenrequired,observethefollowingproceduretotesttheGPSspeedinput.
Relatedtopics
•MonitoringthetrafconaserialorEthernetlineonpage132
•Connectingthespeedlogonpage142
Procedure
1OpentheInstallationmenuasdescribedinOpeningtheInstallationmenuon
page156.
2ClickI/OSetup→Sensors→Speed→SpeedLog.
381293/A
157