Simrad SU90 - Configuring and Testing the Interface to a Catch Monitoring System; Configuring and Testing the Interface to a Radio Buoy System

Interfacingperipheralequipment
Conguringandtestingtheinterfacetoacatchmonitoring
system
Purpose
Observethefollowingproceduretosetupandtestthecatchmonitoringsysteminterface.
Relatedtopics
•MonitoringthetrafconaserialorEthernetlineonpage132
Procedure
1OpentheInstallationmenuasdescribedinOpeningtheInstallationmenuon
page156.
2Selecttheappropriatetrawlsystem.
aTochecktheinterfacetotheSimradITIsystem,clickI/OSetup→Sensors
→Trawlsystem→ITI.
bTochecktheinterfacetotheSimradFS20/25andFS70systems,clickI/O
Setup→Sensors→Trawlsystem→FS3300.
3ObservethattheSensorCongparameterdialogappearsatthebottomofthemenu
eld.
4ChangethesettingsintheSensorCongparameterdialogtosuityourrequirements
forthecommunicationline.
5ClickClosetoexittheSensorCongparameterdialog.
6OpentheSetupmenu.
7ClicktheGearbuttontoaccesstheGearparameterdialogatthebottomofthe
menueld.
8SelectoneofthePursesettings.
9ClicktheEditbuttontoaccesstheNetCongurationparameterdialog.
10Checkthatthedifferentread-outsintheparameterdialogcorrespondstothosefrom
theconnectedcatchmonitoringsystem.
11Ifyouneedorwishtomonitorthedetaileddatatrafconthecommunicationline,
observethededicatedproceduresinsectionMonitoringthetrafconaserialor
Ethernetlineonpage132.
Conguringandtestingtheinterfacetoaradiobuoysystem
Purpose
Observethefollowingproceduretosetupandtesttheradiobuoysysteminterface.
Relatedtopics
•MonitoringthetrafconaserialorEthernetlineonpage132
Procedure
1OpentheInstallationmenuasdescribedinOpeningtheInstallationmenuon
page156.
2ClickI/OSetup→Sensors→BuoySystem→BuoyNMEA.
381293/A
161