Simrad SU90 - Configuring and Testing the Interface to the Positioning System (GPS)

Interfacingperipheralequipment
6Checkthattheheadingread-outintheStatusparameterdialogcorrespondstothe
GPSheading.
7Ifyouneedorwishtomonitorthedetaileddatatrafconthecommunicationline,
observethededicatedproceduresinsectionMonitoringthetrafconaserialor
Ethernetlineonpage132.
(D)GPSheadingdata(seriallineinterface)
Purpose
IftheGPSisusedforthecoursegyroinput,waitwiththistestuntiltheGPSposition
dataaretested.Whenrequired,usethefollowingprocedurefortestingtheGPSinput.
Relatedtopics
•MonitoringthetrafconaserialorEthernetlineonpage132
•Connectingthecoursegyroonpage143
Procedure
1OpentheInstallationmenuasdescribedinOpeningtheInstallationmenuon
page156.
2ClickI/OSetup→Sensors→Heading→Gyro.
3ObservethattheSensorCongparameterdialogappearsatthebottomofthemenu
eld.
4ChangethesettingsintheSensorCongparameterdialogtosuityourrequirements
fortheserialline.
5ClickClosetoexittheSensorCongparameterdialog.
6Checkthattheheadingread-outintheStatusparameterdialogcorrespondstothe
GPSheading.
7Ifyouneedorwishtomonitorthedetaileddatatrafconthecommunicationline,
observethededicatedproceduresinsectionMonitoringthetrafconaserialor
Ethernetlineonpage132.
Conguringandtestingtheinterfacetothepositioning
system(GPS)
Purpose
Observethefollowingproceduretosetupandtestthepositioningsystem(GPS)input.
Relatedtopics
•MonitoringthetrafconaserialorEthernetlineonpage132
Procedure
1OpentheInstallationmenuasdescribedinOpeningtheInstallationmenuon
page156.
2ClickI/OSetup→Sensors→Pos.System→GPS.
3ObservethattheSensorCongparameterdialogappearsatthebottomofthemenu
eld.
381293/A
159