TECO A510s - Page 139

4-61
Group 12: Monitoring Parameters
Code Parameter Name Setting Range Default Unit
Control mode
Attribute
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
SLV2
Current Fault
12-54
Frequency
Command of
Previous Fault
Display frequency
command of previous
fault
- Hz O O O O O O O
12-55
Output Frequency
of Previous Fault
Display output frequency
of previous fault
- Hz O O O O O O O
12-56
Output Current of
Previous Fault
Display output current of
previous fault
- A O O O O O O O
12-57
Output Voltage of
Previous Fault
Display output voltage of
previous fault
- V O O O O O O O
12-58
DC Voltage of
Previous Fault
Display DC voltage of
previous fault
- V O O O O O O O
12-59
DIO Status of
Previous Fault
Display DI/DO status of
previous fault
Description is similar to
12-05
- - O O O O O O O
12-60
Inverter Status of
Previous Fault
Display inverter status of
previous fault
Description is similar to
12-43
- - O O O O O O O
12-61
Trip Time 1 of Last
Fault
Display the operation time
of last time’s fault, 12-62
is the days, while 12-61 is
the remaining hours .
- Hr O O O O O O O
12-62
Trip Time 2 of Last
Fault
- day O O O O O O O
12-63
Recent Warning
Messages
Display the recent
warning messages
- - O O O O O O O
12-64
Previous Warning
Message
Display the previous
warning message
- - O O O O O O O
12-65
Motor Start Angle 0~360
- - X X X X O X X
12-66
Encoder Angle 0~360
- - X O X O O X X
12-67
Cumulative
Energy (KWHr)
0.0 ~ 999.9 kWHr O O O O O O O
12-68
Cumulative
Energy (MWHr)
0 ~ 60000
MWH
r
O O O O O O O
12-69
~
12-75
Reserved
12-76
No-Load Voltage
Output
0.0~600.0 - V X X O X X X X
12-77 Reserved
12-78
Z-Phase Bias
Value
-9999~9999 - Pulse X X X O O X X
12-79
Pulse Input
Percentage
0.0~100.0 -
%
O O O O O O O
*: Refer to the following attachment 1
** A510S 200V 50HP (and the above) and 400V 100HP (and the above) don’t support heatsink temperature
display function.