TECO A510s - Page 138

4-60
Group 12: Monitoring Parameters
Code Parameter Name Setting Range Default Unit
Control mode
Attribute
V/F
V/F
+PG
SLV SV
PM
SV
PM
SLV
SLV2
(100% corresponds to the
maximum frequency set
by 01-02 or 01-16)
12-39
PID Feedback
Display the feedback
value of the PID controller
(100% corresponds to the
maximum frequency set
by 01-02 or 01-16)
- % O O O O O O O
12-40 Reserved
12-41
Heatsink
Temperature*
Display the heatsink
temperature of IGBT
temperature**
*
℃
O O O O O O O
12-42
RS-485 Error
Code
0000 0000
1: CRC Error
1: Data length Error
1: Data Function Error
1: Parity Error
1: Overrun Error
1: Framing Error
1: Time out Error
Reserved
- - O O O O O O O
12-43 Inverter Status
0000 0000
1: Inverter ready
1: During running
1: During zero speed
1: During speed agree
1: During fault detection (minor fault)
1: During fault detection (major fault)
Reserved
- - O O O O O O O
12-44
Pulse Input
Frequency
Display the frequency
value of pulse input
- Hz O O O O O O O
12-45
Recent Fault
Message
Display current fault
message
- - O O O O O O O
12-46
Previous Fault
Message
Display previous fault
message
- - O O O O O O O
12-47
Previous Two
Fault Messages
Display previous two fault
messages
- - O O O O O O O
12-48
Previous Three
Fault Messages
Display previous three
fault messages
- - O O O O O O O
12-49
Previous Four
Fault Messages
Display previous four fault
messages
- - O O O O O O O
12-50
DIO Status of
Current Fault
Display the DI/DO status
of current fault
Description is similar to
12-05
- - O O O O O O O
12-51
Inverter Status of
Current Fault
Display the inverter status
of current fault
Description is similar to
12-43
- - O O O O O O O
12-52
Trip Time 1 of
Current Fault
Display the operation time
of current fault, 12-53 is
the days, while 12-52 is
the remaining hours.
- Hr O O O O O O O
12-53 Trip Time 2 of - day O O O O O O O