TECO A510s - Page 381

4-303
When the analog input is at maximum (10V or 20mA), the torque limit is 100% of the motor rated torque. In order
to increase the torque limit above 100% the analog input gain (04-07) has to set to a value greater than 100%. For
example: 200.0% of the gain will result in the torque limit of 200% of motor rated torque at 10V (20mA) analog
input level.
21-09
Maximum frequency of position control
Range
0.1~100 Hz
21-10
The command of rotation cycle number of section 0
Range
-9999~9999
21-11
The command of the pulse number of section 0
Range
-9999~9999
21-12
The command of rotation cycle number of section 1
Range
-9999~9999
21-13
The command of the pulse number of section 1
Range
-9999~9999
21-14
The command of rotation cycle number of section 2
Range
-9999~9999
21-15
The command of the pulse number of section 2
Range
-9999~9999
21-16
The command of rotation cycle number of section 3
Range
-9999~9999
21-17
The command of the pulse number of section 3
Range
-9999~9999
21-18
The command of rotation cycle number of section 4
Range
-9999~9999
21-19
The command of the pulse number of section 4
Range
-9999~9999
21-20
The command of rotation cycle number of section 5
Range
-9999~9999
21-21
The command of the pulse number of section 5
Range
-9999~9999
21-22
The command of rotation cycle number of section 6
Range
-9999~9999
21-23
The command of the pulse number of section 6
Range
-9999~9999
21-24
The command of rotation cycle number of section 7
Range
-9999~9999
21-25
The command of the pulse number of section 7
Range
-9999~9999