VA Motion Controller Programming Manual
24
5.2 Processor type software installation
1) After installing the mmmm software, continue to install the processor type software. When
the installation dialog appears, click "Next" as shown
2) Select "I accept ......", click on "Next" as shown.
3) Select the installation path, here select the default, display "Version found", click "Next" as
shown in the figure (special attention; the processor type software must be consistent with the
installation path of the MULTIPROG programming software, the processor type software defaults
with the installation The installation path of MULTIPROG programming software is the same, no
need to change. If “Version not found” is displayed, the installation path needs to be changed to be
the same as the installation path of MULTIPROG programming software.
To Next Page
Loading...
Need help?
General
