VA Motion Controller Programming Manual
634
Appendix VI Error Codes
Axis axis number is set beyond the permitted range
Acceleration Acceleration setting beyond the permitted
range
Deceleration deceleration setting beyond the permitted
range
Jerk Jerk is set outside the permitted range
Velocity speed setting beyond the permitted range
Location PositionOutside the allowable range is set
Direction setting direction beyond the permitted range
Outside the permitted range set BufferMode
ReferenceType setting function beyond the permitted range
SetPosition
Electronic cam beyond the permitted range table
Spindle axis number MasterSetting error
Electronic Cam Start Mode StartModeOutside the allowable
range is set
Electronic cam beyond the permitted range set MasterScaling
Electronic cam beyond the permitted range set SlaveScaling
Spindle Source MasterValueSourceOutside the allowable range
is set
From the main shaft number conflicts
Electronic gear numeratorRatioNumeratorOutside the
allowable range is set
(≥0)
Electronic gear denominatorRatioDoutside the permitted
range set enominator
(> 0)
VelFactor MC_SetOverride parameter setting function outside
the permitted range (0 to 500)
Range Error electronic cam SlaveRange
TriggerInput MC_TouchProbe feature set of range
(0 ~15)
Mode MC_TouchProbe function setting error
RotaryAxisRadius set out of range (> 0)
FeedAxisRadius set out of range (> 0)
CutLength set out of range (> 0)
SyncAngle setting out of the allowable range (0 ~360)
Peeling is no such function parameters
RotaryAxisKnifeNum set outside the permitted range (1-16)
NS_MC_SpecialCamIn is equal to 1/2 Mode, MaterValueSource
not be 0
To Next Page
Loading...
Need help?
General
