VA Motion Controller Programming Manual
629
4.2 tension control shaft arranged
4.2.1 Communication configuration------same as: 4.1.1 Communication configuration
4.2.2 Reset the master-slave node ------- same as: 4.1.2 Reset the master-slave node
4.2.3 Master-slave node Enters the pre-main operation ------- same as: 4.1.3 Master-slave
node Enters the pre-main operation
4.2.4 Configure the synchronizing cycle of master-slave node---------------- same as: 4.1.4
Configure the synchronizing cycle of master-slave node
4.2.6 Start Bus ---------------- 4.1.6 Start Bus
4.2.5 Configure the Process data of master-slave node master
To Next Page
Loading...
