Vector VEC-VA Series

VA Motion Controller Programming Manual
635
When the mode is equal to 2/3/4 NS_MC_RotaryCutIn,
MaterValueSource not be 0
0x1046
MC_AXIS_REF, Sample_Time set beyond the permitted range
0x1047
MC_AXIS_REF, Closed_Loop_Scaling set beyond the permitted
range
0x1048
MC_AXIS_REF, Reductor_Den set beyond the permitted range
(> 0)
0x1049
MC_AXIS_REF, Reductor_Num set beyond the permitted range
(> 0)
0x1050
MC_AXIS_REF, Screw_Lead beyond the permitted range, and
setting Disc_Circumference
(> 0)
0x1051
MC_AXIS_REF, Revolving_Axes 1 is set beyond the permitted
range Modulo
(> 0)
0x1052
MC_AXIS_REF, ControlMode set beyond the permitted range
0x1053
MC_AXIS_REF, Moter_Max_V set beyond the permitted range
0x1054
MC_AXIS_REF, Moter_PPC set beyond the permitted range
0x1055
MC_AXIS_REF, Offset_Max_V set beyond the permitted range
0x1056
MC_CamIn, ActivationMode is 2, ActivationPosition less than
0 or greater than the mold
NS_MC_SpecialCamIn, ActivationPosition setOut of the
allowable range (≧ 0)
0x1057
NS_MC_SpecialCamIn, DistanceOffset_Master setOut of the
allowable range (≧ 0)
0x1058
DistanceAdd set outside the permitted range (≧ 0)
0x1059
DistanceSync set outside the permitted range (≧ 0)
0x1060
DistanceDec set outside the permitted range (≧ 0)
0x1061
NC_CartesianCoordinate beyond the permitted range setting
module Depth
0x1062
NC_CartesianCoordinate beyond the permitted range setting
module Junction_Deviation
0x1063
NC_CartesianCoordinate beyond the permitted range setting
module Arc_Tolerance
0x1064
NS_MC_SpecialCombineAxes beyond the permitted range setting
module Cam_DistanceOffset_Master
(> 0)
0x1068
NS_MC_SpecialCombineAxes module Cam_Pulse_Per_Unit_M set
outside the permitted range (> 0)
0x1069
NS_MC_SpecialCombineAxes module NCFile specified file was
not found
0x1070
NC_MoveCircular, CircMode set out of the allowable range (0
to 2)