This symbol indicates that the operatioNShould be noted.
General Safety Summary
Please review the following safety precautions to avoid injury and prevent
damage to this product or any products connected to it. To avoid potential danger,
follow the instructions to use the product in detail. Use a power cord that meets
national standards. Properly connecteDAnd disconnected. The electrical wiring is
correct before the control requirements, the power up sequence requires the user
to control the opening movement, the servo drive is turned on, power-off sequence
for the first servo drive off, the motion controller off (refer to VADetails motion
controller hardware specification Chapter IX of this manual or quick start wiring
instructions)
When a suspected fault do not operate and if you suspect the product is
damaged. Please have a qualified service person check it.
Do not operate in a wet / moist environment.
Do not operate in an explosive atmosphere.
Keep the products surface clean and dry.
Prevent electrostatic damage. Electrostatic discharge (ESD) may cause the
motion controller and its attachment elements in damage. To prevent ESD, Be
careful of control member, do not touch the controller components. Do not place
the controller on the surface of static electricity may be generated. Transport and
storage controllers in protective static bags or containers.
Product’s range of applications
To Next Page
Loading...
Need help?
General
