Vector VEC-VA Series

VA Motion Controller Programming Manual
49
is
FALSE
(
0
) , the function defined by the instruction will not be executed, and the output value of
the output pin of the instruction will not be refreshed. . Conversely, if the
EN
pin parameter
value defined by the instruction is
TRUE
(
1
) , the function defined by the instruction will be
executeDAnd the value of the instruction output pin will be refreshed.
(
2
)
ENO
pin output and the
EN
input pins consistent,
EN
pin
is
TRUE
,
ENO
piNSimultaneously becomes
TRUE
;
EN
pin is
FALSE
,
ENO
piNSimultaneously
becoming
FALSE
. When the instruction is a function block (
FB
), if the function block (
FB
) is
executed,
EN
changes from
TRUE
to
FALSE
, the function block (
FB
) continues to execute, but
the value of the output block of the function block (
FB
) does not Was refreshed.
2
: How to set logic instructions with
EN
and
ENO
without
EN
and
ENO
(
1
) Put the mouse under the programming interface, the menu bar will automatically add the
"Object" menu, click
-> "
Object
" ->
Select
"
Insert Block with
EN/ENO "
, and later from the "Edit
Wizard" The function module that is dragged out will be self-
EN/ENO
; when the function is not
used, the above operation can be repeated. The following figure illustrates
(
2
) The function block without
EN/ENO
has been called . If you want to increase
the
EN/ENO
function, the mouse selects the programming interface. At this time, the menu bar will
automatically add the “ Object ” menu, click -> “ Object ” -> select "insert with EN /
ENO
blocks", and theNSelect the need to add
EN / ENO
functional blocks, right
->
select
>