VA Motion Controller Programming Manual
76
(Note ! "In the newly established Project Wizard
PLC
processor type" is selected, processor
type, select the "simulation
eCLR_Simulation
"; physical
PLC
processor type selection
"
ARM_LE_GCC3
"; for this kind of simulation engineering projects and engineering Switch
between projects)
2
) Right-click "Resources" under "Project Tree Window" and select "Settings" in the pop-up
"
ARM_LE_GCC3
Resource Settings" window to set:
Select "
TCP /IP
" under the communication "Type ";
Set the
IP
address under the "Parameter" of the communication to
"
1 92 . 168 . 1 . 123 - p41100
"
To Next Page
Loading...
