VA Motion Controller Programming Manual
80
4
, click
<
driver parameters
>,
" in the driver name" was changed to "
KWIO
" shown in FIG.
5
, repeating the above steps for the same output terminal of the set
,
select "
the OUTPUT
",
"name" click "Add" to the output "
OUT
", the logical address "length" was changed to
16
, and the
"driver name "Modify to "
KWIO
" and click "OK" to complete the
I/O
driver setup .
Note:
I/O
settings are required each time the user creates a new project .
To Next Page
Loading...
