11-19
IM 701210-06E
Waveform Analysis/Search
11
For Marker Cursors (When Not Displaying the X-Y Waveform)
MEASURE
CURSOR RESET SELECT
CH
ALL CH
MODE
POSITION
SIMPLE/ENHANCED
ACQ
START/STOP
SETUP DISPLAY
ZOOM
DUAL
CAPTURE
HISTORY
MATH
1
CH
2
CH
3
CH
4
CH
5
CH
6
CH
7
CH
8
CH
9
CH
10
CH
11
CH
12
CH
13
CH
14
CH
15
CH
16
DELAY
MANUAL TRIG
V/DIV TIME/DIV
TRIGGER
TRIG D
VERTICAL
HORIZONTAL
CAL
X-Y
SEARCH
7
DSP 1
8 9
DSP 2
654
1
0
23
ENTER
m
DSP 6DSP 5
LOGIC A
LOGIC B
EVENT
DSP 3 DSP 4
EXP
GO/NO-GO
ACTION
FILE
SHIFT
1. Press CURSOR.
Selecting the Cursor Type
2. Press the Type soft key. The cursor type selection menu appears.
3. Press the Marker soft key.
Selecting the Marker
4. Press the Select soft key to select the desired marker from M1 to M4.
Selecting the Waveform to Be Measured
5. Press the Trace soft key. The trace selection menu appears.
6. Press the soft key corresponding to the desired waveform to select the
waveform to be measured.
Moving the Cursor
7. Press the Position soft key and turn the jog shuttle to move the cursor
As the cursor is moved, the displayed value of Position changes.
DSP1 to DSP6 are optional.
11.5 Measuring Waveforms Using Cursors
To Next Page
Loading...
