Danfoss VLT series

Value Denition
0 Reserved
1 Segment ID
2 Starting node
3 Ending node
4 Start action
5 End action
6 Default segment
7 Movement type
8 Start position
9 Start velocity
10 Start acceleration
11 Distance
12 End velocity
13 End acceleration
64–69 Coes a0–a5
Table 7.136 Parameter IDs for GuidePoly Segment
Value Denition
0 Reserved
1 Segment ID
2 Starting node
3 Ending node
4 Start action
5 End action
6 Default segment
7 Start position
8 Start velocity
9 Start acceleration
10 End velocity
11 End acceleration
Table 7.137 Parameter IDs for Move Distance Segment
Value Denition
0 Reserved
1 Segment ID
2 Starting node
3 Ending node
4 Start action
5 End action
6 Default segment
7 Partition
8 Revolutions
9 Oset
Table 7.138 Parameter IDs for Return Segment
Servo Drive Parameter Descr... Programming Guide
MG36D102 Danfoss A/S © 01/2017 All rights reserved. 297
7 7