Danfoss VLT series Programming Guide

Value Denition
0 Reserved
1 Segment ID
2 Starting node
3 Ending node
4 Start action
5 End action
6 Default segment
7 Duration
8 Exit condition
9 Movement type
10 Start position
11 Velocity
12 Acceleration
13 Deceleration
14 Torque limit
Table 7.142 Parameter IDs for Velocity Segment
Value Denition
0 Reserved
1 Segment ID
2 Starting node
3 Ending node
4 Start action
5 End action
6 Default segment
7 Duration
8 Exit condition
9 Movement type
10 Start position
11 Torque
12 Ramp
13 Speed limit
Table 7.143 Parameter IDs for Torque Segment
Value Denition
0 Reserved
1 Segment ID
2 Starting node
3 Ending node
4 Start action
5 End action
6 Default segment
7 Duration
8 Exit condition
9 Movement type
10 Start position
11 Velocity ration
12 Acceleration
13 Deceleration
14 Torque limit
Table 7.144 Parameter IDs for Sync Segment
Servo Drive Parameter Descr... Programming Guide
MG36D102 Danfoss A/S © 01/2017 All rights reserved. 299
7 7

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)