EasyManua.ls Logo

Dell PowerConnect 5324 - Add SNTP Interface; Table; SNTP Broadcast CLI Commands

Dell PowerConnect 5324
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
102 Configuring System Information
www.dell.com | support.dell.com
Receive Server Updates
Remove
— Removes SNTP from a specific interface, when selected.
Adding an SNTP Interface
1
Open the
SNTP Broadcast Interface Table
page.
2
Click
Add.
The
Add SNTP Interface
page opens:
Figure 6-28. Add SNTP Interface Page
3
Define the relevant fields.
4
Click
Apply Changes
.
The SNTP interface is added, and the device is updated.
Defining SNTP Interface Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNTP Broadcast Interface Table
.
The following is an example of the CLI commands:
Table 6-20. SNTP Broadcast CLI Commands
CLI Command Description
sntp client enable E
nables the Simple Network Time Protocol
(SNTP) client on an interface.
show sntp configuration
Shows the configuration of the Simple
Network Time Protocol (SNTP).

Table of Contents

Other manuals for Dell PowerConnect 5324

Related product manuals