Dell PowerConnect 5324 - Add Trap Receiver;Manager

Configuring System Information 183
SNMP traps are enabled on the device.
Enabling Authentication Traps on the Device
1 Open the SNMP Trap Settings page.
2 Select Enable in the Authentication Trap drop-down list.
3 Define the fields.
4 Click Apply Changes .
Authentication traps are enabled on the device.
Adding a New Trap Recipient:
1 Open the SNMP Trap Settings page.
2 Click Add .
The
Add Trap Receiver/Manager page opens:
Figure 6-74. Add Trap Receiver/Manager
3
Define the fields. Configuring 0.0.0.0 means "All", and the traps are broadcast.
4 Click Apply Changes .
The Trap Recipient/Manager is added, and the device is updated.
Displaying the Trap Managers Table
The Trap Managers Table contains fields for configuring trap types.
1 Open SNMP Trap Settings page.
2 Click Show All.
The Trap Managers Table page opens: