Configuring Quality of Service 341
The following table summarizes the equivalent CLI commands for configuring fields in the
QoS
Settings
page.
The following is an example of the CLI commands:
Defining QoS Interface Settings
The
Interface Cos/QoS Settings
page contains fields for defining, per interface, if the selected
Trust mode is to be activated. The default priority for incoming untagged packets is also selected in
the
Interface Cos/QoS Settings
page, click
Quality of Service
→
CoS Global Parameters
→
Interface Settings
in the tree view.
Figure 9-131. Interface Cos/QoS Settings
Table 9-94. CoS Setting CLI Commands
CLI Command Description
qos trust
[
cos
|
dscp
] Configures the system to basic mode and the
"trust" state.
no cos trust
Returns to the non-trusted state.
Console (config)# cos trust dscp
To Next Page
Loading...
