Dell PowerConnect 5324 User Manual

136 Configuring System Information
www.dell.com | support.dell.com
Remove ARP Entry — When selected, removes an ARP entry.
Adding a Static ARP Table Entry:
1 Open the ARP Settings page.
2 Click Add .
The
Add ARP Entry page opens:
Figure 6-47. Add ARP Entry Page
3
Select an interface.
4 Define the fields.
5 Click Apply Changes .
The
ARP Table entry is added, and the device is updated.

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2