Configuring Device Information 199
Configuring Port Based Authentication
The
Port Based Authentication
page
contains fields for configuring port based authentication. To
open the
Port Based Authentication
page, click
Switch
→
Network Security
→
Port Based
Authentication
.
Figure 7-80. Port Based Authentication
Port Based Authentication State
— Permits port based authentication on the device. The possible
field values are:
Enable
— Enables port based authentication on the device.
Disable
— Disables port based authentication on the device.
Authentication Method
— The Authentication method used. The possible field values are:
None
— No authentication method is used to authenticate the port.
RADIUS
— Port authentication is performed using the RADIUS server.
RADIUS, None
— Port authentication is performed first using the RADIUS server. If the port
is not authenticated, then no authentication method is used, and the session is permitted.
Interface
— Contains an interface list.
User Name
— The user name as configured in the RADIUS server.
Admin Interface Control
— Defines the port authorization state. The possible field values are:
Authorized
— Set the interface state to authorized (permit traffic).
To Next Page
Loading...
