Configuring Quality of Service 343
Assigning CoS Interfaces Using the CLI Commands
The following table summarizes the equivalent CLI commands for configuring fields in the
Interface Cos/QoS Settings
page.
The following is an example of the CLI commands:
Table 9-95. CoS Interface CLI Commands
CLI Command Description
qos trust Enables trust state for each.
qos cos default-cos Configures the default port CoS value.
no qos trust Disables Trust state on each port.
Console (config)# interface ethernet g5
Console (config-if)# qos trust
Console (config-if)# qos cos 3
To Next Page
Loading...
