EasyManuals Logo

Dell PowerConnect 5324 User Manual

Dell PowerConnect 5324
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #48 background imageLoading...
Page #48 background image
48 Starting and Configuring the Device
www.dell.com | support.dell.com
Configuration Overview
Before assigning a static IP address to the device, obtain the following information:
A specific IP address that has been allocated to the device in order for it to be configured.
Default route.
Network mask for the network.
There are two configuration types:
Initial Configuration
— Consists of configuration functions with basic security
considerations.
Advanced Configuration
— Consists of dynamic IP configuration and more advanced
security considerations.
NOTE: After making any configuration changes, the new configuration must be saved before rebooting.
To save the configuration, enter:
console# copy running-config startup-config
Initial Configuration
NOTE: Before proceeding, read the release notes for this product. The release notes can be
downloaded from Dell support website at support.dell.com.
NOTE: The initial simple configuration uses the following assumptions:
The PowerConnect device was never configured before, and is in the same state as when it was
received.
The PowerConnect device booted successfully.
The Serial connection is established and the console prompt is displayed on the screen of a VT100
terminal device. (Press the <Enter> key several times to verify that the prompt displays correctly.)
The device is not configured with a default user name and password.
The initial device configuration is through the Serial port. After the initial configuration, the
device can then be managed either from the already connected Serial port or remotely through an
interface defined during the initial configuration.
The initial configuration consists of the following:
Setting the user name 'admin', password as 'dell' with the highest privilege level of 15.
Configuring the static IP address and the default gateway.
Configuring the SNMP read/write community string.
Assigning the IP address allocated by the DHCP server.
Before applying the initial configuration procedure to the PowerConnect device, the following
information must be obtained from the network administrator:
The IP address to be assigned to a VLAN through which the device is managed.

Table of Contents

Other manuals for Dell PowerConnect 5324

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell PowerConnect 5324 and is the answer not in the manual?

Dell PowerConnect 5324 Specifications

General IconGeneral
Switching Capacity48 Gbps
VLAN SupportYes
Rack MountableYes
Device TypeSwitch
MAC Address Table Size8K entries
RAM64 MB
Flash Memory8 MB
Power DeviceInternal power supply
Voltage RequiredAC 120/230 V (50/60 Hz)
Jumbo Frame SupportYes
Ports24 x 10/100/1000 + 2 x SFP
ManagementWeb-based, SNMP, CLI
Enclosure TypeRack-mountable
Routing ProtocolStatic IP routing
Remote Management ProtocolSNMP 1, 2, 3
FeaturesFlow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant StandardsIEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature0 °C to 45 °C
Storage Temperature-20 °C to 70 °C
Humidity5% to 95% (non-condensing)
LayerLayer 2

Related product manuals