Dell PowerConnect 5324 User Manual

202 Configuring Device Information
www.dell.com | support.dell.com
Enabling Port Based Authentication Using the CLI Commands
The following table summarizes the equivalent CLI commands for enabling the port based
authentication as displayed in the
Port Based Authentication page.
.
Table 7-49. Port Authentication CLI Commands
CLI Command Description
aaa authentication dot1x
default method1 [method2.]
Specifies one or more authentication,
authorization, and accounting (AAA) methods
for use on interfaces running IEEE 802.1X.
dot1x max-req count Sets the maximum number of times that the
device sends an EAP to the client, before
restarting the authentication process.
dot1x re-authenticate
[ethernet interface]
Manually initiates a re-authentication of all
802.1X-enabled ports or the specified 802.1X-
enabled port.
dot1x re-authentication Enables periodic re-authentication of the client.
dot1x timeout quiet-period
seconds
Sets the number of seconds that the
device
remains in the quiet state following a failed
authentication exchange.
dot1x timeout re-authperiod
seconds
Sets the number of seconds between re-
authentication attempts.
dot1x timeout server-
timeout seconds
Sets the time for the retransmission of packets to
the authentication server.
dot1x timeout supp-timeout
seconds
Sets the time for the retransmission of an EAP
request frame to the client.
dot1x timeout tx-period
seconds
Sets the number of seconds that the
device waits
for a response to an EAP - request/identity frame,
from the client, before resending the request.
show dot1x [ethernet
interface]
Displays 802.1X status for the
device or for the
specified interface.
show dot1x users [username
username]
Displays 802.1X users for the
device .

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2