Dell PowerConnect 5324 - Add TACACS+ Host; TACACS+ Table

Configuring System Information 167
The TACACS+ default parameters are user-defined defaults. The default settings are applied to
newly defined TACACS+ servers. If default values are not defined, the system defaults are applied
to the new TACACS+ new servers. The following are the TACACS+ defaults:
Source IP Address — The default device source IP address used for the TACACS+ session
between the device and the TACACS+ server.
Key String (0-128 Characters) — The default authentication and encryption key for TACACS+
communication between the device and the TACACS+ server.
Timeout for Reply (1-30) — The default time that passes before the connection between the
device and the TACACS+ times out.
Adding a TACACS+ Server
1 Open the TACACS+ Settings page.
2 Click Add.
The Add TACACS+ Host page opens:
Figure 6-65. Add TACACS+ Host
3
Define the fields.
4 Click Apply Changes .
The TACACS+ server is added, and the device is updated.
Displaying the TACACS+ Table
1 Open the TACACS+ Settings page.
2 Click Show All .
The
TACACS+ Table opens:
Figure 6-66. TACACS+ Table