Dell PowerConnect 5324 User Manual

192 Configuring System Information
www.dell.com | support.dell.com
Source — Copies either the Running Configuration, Startup Configuration or Backup
Configuration files.
Destination — The file to which the Running Configuration, Startup Configuration or
Backup Configuration file is copied.
Restore Configuration Factory Defaults — When selected, specifies that the factory configuration
default files should be reset. When unselected, maintains the current configuration settings.
Copying Files
1 Open the Copy Files page.
2 Define the Source and Destination fields.
3 Click Apply Changes .
The file is copied, and the device is updated.
Restoring Company Factory Default Settings
1 Open the Copy Files page.
2 Click Restore Company Factory Defaults .
3 Click Apply Changes .
The company factory default settings are restored, and the device is updated.
Copying and Deleting Files Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
Copy Files
page.
Table 6-47. Copy Files CLI Commands
CLI Command Description
copy source-url destination-
url [snmp]
Copies any file from a source to a destination.
delete startup-config Deletes the startup-config file.

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2