Dell PowerConnect 5324 - Defining IP Interfaces; IP Interface Parameters

120 Configuring System Information
www.dell.com | support.dell.com
The following is an example of the CLI commands:
Defining IP Interfaces
The IP Interface Parameters page contains fields for assigning IP parameters to interfaces. To open
the
IP Interface Parameters page, click System → IP Addressing → Interface Parameters in the tree
view.
Figure 6-35. IP Interface Parameters
IP Address — The interface IP address.
Prefix Length — The number of bits that comprise the source IP address prefix, or the network
mask of the source IP address.
Interface — The interface type for which the IP address is defined. Select Port , LAG , or VLAN .
For more information, see "Configuring VLANs".
Ty p e — Indicates whether or not the IP address was configured statically.
Forward Directed IP Broadcasts — Enables the translation of a directed broadcast to physical
broadcasts. Disabling drops IP-directed broadcasts and does not forward them.
Broadcast Type — Defines an interface broadcast address.
One Fill — The interface broadcast address is one fill (255.255.255.255).
Zero Fill — The interface broadcast address is zero fill (0.0.0.0).
Console (config)# ip default-gateway 196.210.10.1
Console (config)# no ip default-gateway