Configuring System Information 171
Figure 6-67. RADIUS Settings
IP Address
— The list of Authentication Server IP addresses.
Priority (1-65535)
— Specifies the server priority. The possible values are 1-65535, where 1 is the
highest value. This is used to configure the order in which servers are queried.
Authentication Port
— Identifies the authentication port. The authentication port is used to verify
the RADIUS server authentication.
Number of Retries (1-10)
— Specifies the number of transmitted requests sent to RADIUS server
before a failure occurs. The possible field values are 1 - 10. Three is the default value.
Timeout for Reply (1-30
) — Specifies the amount of the time in seconds the device waits for an
answer from the RADIUS server before retrying the query, or switching to the next server. The
possible field values are 1 - 30. The default is 3.
Dead Time (0-2000)
— Specifies the amount of time (in seconds) that a RADIUS server is
bypassed for service requests. The range is 0-2000.
Key String (1-128 Characters)
— Specifies the Key string used for authenticating and encrypting
all RADIUS communications between the device and the RADIUS server. This key is encrypted.
To Next Page
Loading...
