Dell PowerConnect 5324 - Page 172

172 Configuring System Information
www.dell.com | support.dell.com
Source IP Address — Specifies the source IP address that is used for communication with RADIUS
servers.
The following fields set the RADIUS default values:
Default Timeout for Reply (1-30) — Specifies the default amount of the time (in seconds) the
device waits for an answer from the RADIUS server before timing out.
NOTE: If host-specific Timeouts, Retries, or Dead time values are not specified, the Global values
(Defaults) are applied to each host.
Default Retries (1-10) — Specifies the default number of transmitted requests sent to RADIUS
server before a failure occurs.
Default Dead time (0-2000) — Specifies the default amount of time (in seconds) that a RADIUS
server is bypassed for service requests. The range is 0-2000.
Default Key String (1-128 Characters) — Specifies the Default Key string used for authenticating
and encrypting all RADIUS communications between the device and the RADIUS server. This key
is encrypted.
Source IP Address — Specifies the source IP address that is used for communication with RADIUS
servers.
Usage Type — Specifies the server usage type. Can be one of the following values: login , 802.1x or
all . If unspecified, defaults to all .
Defining RADIUS Parameters:
1 Open the RADIUS Settings page.
2 Define the fields.
3 Click Apply Changes .
The RADIUS setting are updated to the device.
Adding a RADIUS Server:
1 Open the RADIUS Settings page.
2 Click Add .
The
Add RADIUS Server page opens: