Dell PowerConnect 5324 - Figure 6-26. Add SNTP Server; Table; SNTP Server CLI Commands

98 Configuring System Information
www.dell.com | support.dell.com
Adding an SNTP Server
1 Open the SNTP Servers page.
2 Click Add.
The Add SNTP Server page opens:
Figure 6-26. Add SNTP Server
3
Define the fields.
4 Click Apply Changes .
The SNTP Server is added, and the device is updated.
The following table summarizes the equivalent CLI commands for setting fields displayed in the
Add SNTP Server
page.
Table 6-18. SNTP Server CLI Commands
The following is an example of the CLI commands:
Displaying the SNTP Server Table
1 Open the SNTP Servers page.
2 Click Show All.
The SNTP Servers Table opens:
CLI Command Description
sntp server ip-
address|hostname [poll] [key
keyid]
Configures the to use SNTP to request
and accept NTP traffic from a server.
console> enable
console# configure
Console(config)# sntp server 100.1.1.1 poll key 10