206 Configuring Device Information
www.dell.com | support.dell.com
The following is an example of the CLI Command.
Table 7-50. Multiple Hosts CLI Commands
CLI Command Description
dot1x multiple-hosts Allows multiple hosts (clients) on an 802.1X-
authorized port that has the dot1x port-control
interface configuration command set to auto.
dot1x single-host-
violation {forward
|discard |discard-
shutdown}[trap
seconds]
Configures the action to be taken when a station,
whose MAC address is not the client (supplicant)
MAC address, attempts to access the interface.
Neyland# configure
Neyland(config)# interface ethernet g1
Neyland(config-if)# dot1x multiple-hosts
To Next Page
Loading...
