Dell PowerConnect 5324 - Trap Managers Table; SNMP Trap Settings CLI Commands

184 Configuring System Information
www.dell.com | support.dell.com
Figure 6-75. Trap Managers Table
Deleting a Trap Manager Table Entry
1 Open SNMP Trap Settings page.
2 Click Show All.
The Trap Managers Table page opens.
3 Select a Trap Managers Table entry.
4 Select the Remove check box.
5 Click Apply Changes .
The selected trap manager is deleted, and the device is updated.
Configuring Traps Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
SNMP Trap Settings
page.
Table 6-44. SNMP Trap Settings CLI Commands
CLI Command Description
snmp-server enable traps Enables the
device to send SNMP traps or SNMP
notifications.
snmp-server trap
authentication
Enables the
device to send SNMP traps when
authentication failed.
snmp-server host host-addr
community-string [1 | 2]
Determines the trap type sent to the selected
recipient.
show snmp Displays the SNMP communications status.