Dell PowerConnect 5324 User Manual

78 Configuring System Information
www.dell.com | support.dell.com
Configuring Device Information Using the CLI Commands
The following table summarizes the equivalent CLI commands for viewing and setting fields
displayed in the
Asset page .
The following is an example of the CLI commands:
Table 6-11. Asset CLI Commands
CLI Command Description
hostname name
Specifies or modifies the device host name.
snmp-server contact text
Sets up a system contact.
snmp-server location text
Enters information on where the device is
located.
clock set hh:mm:ss day
month year
Manually sets the system clock and date.
show clock [detail]
Displays the time and date from the system
clock.
show system id
Displays the service tag information.
show system
Displays system information.
asset-tag
Sets the device asset tag.
Console (config)# hostname dell
Console (config)# snmp-server contact Dell_Tech_Supp
Console (config)# snmp-server location New_York
Console (config)# exit
Console # exit
Console (config)# asset-tag 1qwepot
Console> clock set 13:32:00 7 Dec 2004
Console> show clock
13:32:00 (UTC+0) Dec 7 2004
No time source

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2