Dell PowerConnect 5324 User Manual

Configuring System Information 107
Enabling Logs Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
Global Log Parameters
page.
The following is an example of the CLI commands:
Table 6-22. Global Log Parameters CLI Commands
CLI Command Description
logging on
Enables error message logging.
logging {ip-address |
hostname} [port port]
[severity level] [facility
facility] [description text]
Logs messages to a syslog server. For a list of the
Severity levels, see "Log Severity Levels" .
logging console level
Limits messages logged to the console based on
severity.
logging buffered level
Limits syslog messages displayed from an internal
buffer (RAM) based on severity.
logging file level
Limits syslog messages sent to the logging file
based on severity.
clear logging
Clears logs.
clear logging file
Clears messages from the logging file .
Console (config)# logging on
Console (config)# logging console errors
Console (config)# logging buffered debugging
Console (config)# logging file alerts
Console (config)# clear logging
Console (config)# exit
Console# clear logging file
Clear Logging File [y/n]y

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2