Dell PowerConnect 5324 User Manual

Configuring System Information 163
The line password for the Telnet sessions is defined, and the device is updated.
Defining Line Passwords for Secure Telnet Sessions
1 Open the Line Password page.
2 Define the Line Password for Secure Telnet field.
3 Click Apply Changes .
The line password for Secure Telnet sessions is defined, and the device is updated.
Assigning Line Passwords Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
Line Password
page.
The following is an example of the CLI commands:
Table 6-39. Line Password CLI Commands
CLI Command Description
password password
[encrypted]
Specifies a password on a line.
Console (config-line)# password dell

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2