Dell PowerConnect 5324 - Add a Static Interface

Configuring System Information 121
Remove — When selected, removes the interface from the IP Address drop-down menu.
Adding an IP Interface
1 Open the IP Interface Parameters page.
2 Click Add .
The
Add a Static Interface page opens:
Figure 6-36. Add a Static Interface
3
Complete the fields on the page.
Network Mask specifies the subnetwork mask of the source IP address.
4 Click Apply Changes .
The new interface is added, and the device is updated.
Modifying IP Address Parameters
1 Open the IP Interface Parameters page.
2 Select an IP address in the IP Address drop-down menu.
3 Modify the required fields.
4 Click Apply Changes .
The parameters are modified, and the device is updated.
Deleting IP Addresses
1 Open the IP Interface Parameters page.
2 Click Show All.
The Interface Parameters Table opens: