Dell PowerConnect 5324 User Manual

310 Viewing Statistics
www.dell.com | support.dell.com
Viewing EAP Statistics
The EAP Statistics page contains information about EAP packets received on a specific port. For
more information about EAP, see "Port Based Authentication (802.1x)" . To open the
EAP
Statistics
page, click Statistics/RMON > Table Views > EAP Statistics in the tree view .
Figure 8-120. EAP Statistics
Port — The port which is polled for statistics.
Refresh Rate — Amount of time that passes before the interface statistics are refreshed.
Frames Receive — The number of valid EAPOL frames received on the port.
Frames Transmit — The number of EAPOL frames transmitted via the port.
Start Frames Receive — The number of EAPOL Start frames received on the port.
Log off Frames Receive — The number of EAPOL Logoff frames that have been received on the
port.
Respond ID Frames Receive — The number of EAP Resp/Id frames that have been received on the
port.
Respond Frames Receive — The number of valid EAP Response frames received on the port.
Request ID Frames Transmit — The number of EAP Requested ID frames transmitted via the
port.
Request Frames Transmit — The number of EAP Request frames transmitted via the port.
Invalid Frames Receive — The number of unrecognized EAPOL frames received on this port.

Dell PowerConnect 5324 Specifications

General

Switching Capacity	48 Gbps
VLAN Support	Yes
Rack Mountable	Yes
Device Type	Switch
MAC Address Table Size	8K entries
RAM	64 MB
Flash Memory	8 MB
Power Device	Internal power supply
Voltage Required	AC 120/230 V (50/60 Hz)
Jumbo Frame Support	Yes
Ports	24 x 10/100/1000 + 2 x SFP
Management	Web-based, SNMP, CLI
Enclosure Type	Rack-mountable
Routing Protocol	Static IP routing
Remote Management Protocol	SNMP 1, 2, 3
Features	Flow control, auto-negotiation, port mirroring, Quality of Service (QoS)
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x
Operating Temperature	0 °C to 45 °C
Storage Temperature	-20 °C to 70 °C
Humidity	5% to 95% (non-condensing)
Layer	Layer 2