168 Configuring System Information
www.dell.com | support.dell.com
Removing a TACACS+ Server
1
Open the
TACACS+ Settings
page.
2
Click
Show All
.
The
TACACS+ Table
opens.
3
Select a
TACACS+ Table
entry.
4
Select the
Remove
check box.
5
Click
Apply Changes
.
The TACACS+ server is removed, and the device is updated.
Defining TACACS+ Settings Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
TACACS+ Settings
page.
Table 6-41. TACACS+ CLI Commands
CLI Command Description
TACACS-server host (ip-
address | hostname) [single-
connection] [port port-
number] [timeout timeout]
[key key-string] [source
source] [priority priority]
Specifies a TACACS+ host.
no TACACS-server host (ip-
address | hostname)
Deletes a TACACS+ host.
tacacs-server key key-string
Specifies the authentication and encryption key
for all TACACS+ communications between the
device and the TACACS+ server. This key must
match the encryption used on the TACACS+
daemon. (Range: 0 - 128 characters.)
tacacs-server timeout timeout Specifies the timeout value in seconds. (Range: 1
- 30.)
To Next Page
Loading...
