Dell PowerConnect 5324 - Profile Rules Table; Access Profiles CLI Commands

Configuring System Information 149
Figure 6-54. Profile Rules Table Page
Removing a Rule
1 Open the Access Profiles page .
2 Click Show All .
The
Profile Rules Table opens.
3 Select a rule.
4 Select the Remove check box.
5 Click Apply Changes .
The selected rule is deleted, and the device is updated.
Defining Access Profiles Using CLI Commands
The following table summarizes the equivalent CLI commands for setting fields displayed in the
Access Profiles
page.
Table 6-35. Access Profiles CLI Commands
CLI Command Description
management access-list
name
Defines an access-list for management, and
enters the access-list context for configuration.
permit [ethernet interface-
number | vlan vlan-id | port-
channel number] [service
service]
Sets port permitting conditions for the
management access list.
permit ip-source ip-address
[mask mask | prefix-length]
[ethernet interface-number |
vlan vlan-id | port-channel
number] [service service]
Sets port permitting conditions for the
management access list, and the selected
management method.